Backer Board To Cover Wood Floors

To achieve the ideal flat surface most contractors rely on the backer board cement backer board is a thin layer of concrete designed to be setting surface upon which tile can be installed.

Backer board to cover wood floors.

If the wood floor is sturdy you can cover it with tile stone or even brick veneer. The backerboard should completely cover the subfloor joints. Installing over wood. Score the board with a utility knife then cut it using a jig saw with a carbide blade.

Find backer board at lowe s today. James hardie hardiebacker 1 4 in. Just as you would with drywall make sure the screwheads are slightly depressed below the cement backer board surface. Chipboard cushioned vinyl flooring particle boards of any type oriented strand board osb interior grade plywood tongue and groove planking and hardwood floors are unsuitable substrates for direct installation of ceramic tile.

Cement board is james hardie hardiebacker 1 4 in. After pressing the boards into the mortar screw them in with screws made especially for cement backer board installation. Works under interior floors to provide a solid foundation for tile vinyl wood and other flooring. If needed cut the backerboard to fit in small spaces or around obstructions.

Cement board is a cement backerboard designed for use with floors and countertops. Its made from cement and sand and is reinforced by fiberglass mats on both sides so it s impervious to water. The backer board comes in different sizes and you will pick the right one depending on the type of floor you are installing. Keep the cement backer boards about 1 4 inch apart.

To install ceramic tile over wood the wood surface must be structurally sound enough to support the weight of the tile. Floor tiles should be installed over smooth flat surfaces. Cover and mortar the seams with fiberglass seam tape. Cement board will also work as a countertop backerboard and underlayment for tile granite and other stone surfaces.

Mix up and apply a modified thinset to a large enough area of the plywood subfloor to cover each piece of backer board using a 1 4 x 1 4 notched trowel. Do a dry run and lay the backerboard down to fully cover the area you plan to tile.