Use a pvc pipe that the frame pipe will fit into.
Awning out of pvc.
Fch window awning door canopy 40 x 40 window awning overhead door modern polycarbonate cover outdoor front door patio canopy uv rain snow sunlight protection hollow sheet silver gray by fch 36 99 36.
The outer pipe has one hole and the inner pipe attached to the awning has multiple holes.
Https youtu be kz0amsvu5uq message me to send you full write up.
You can make a window awning with pvc pipe.
Place the patio awning material on a flat clean surface and fold about a 1 5 8 inch piece over to the wrong side.
Choose a length of pvc and elbow so that the awning hangs at a desired angle.
Pin it 5 8 inch from the end for a couple inches along the length and then take a piece of your pvc pipe and test the fit.
The support brace on each side is similar to the top mounting brace.
Awnings are typically made with a metal frame and are composed of some type of fabric.
Drill one hole about an inch down from the top of the larger pipe.
I did not glue this piece.
I picked the about 45 degrees.
If it s too snug fold a little more fabric over.
I wanted to be able to still see out of the window so if you do too test the angle with someone inside.
Use a d pin or something fancier to set the height.
It helps keep shade over the window.